Here all the probs that are wronge with my car, and maybe you guys can help. I attached pictures to go with them.
OKay i have new fenders so forget the fender. How do I pull that huge dent out of the door. I really don't want to bondo it.
Here we have holes on the ....., not sure what you want to call it. Pillar I think. Its the drivers side, is there any easy way to fix that or am I screwed there?
This is under the car looking at the drivers side floor board as it goes up around. Hard to tell I know. Not sure what to do here either
Here in a pic of the drivers side rocker where it connects to the fender. I have a hole where the tape is.
If you guys have any ideas that would be great. Thanks again
OKay i have new fenders so forget the fender. How do I pull that huge dent out of the door. I really don't want to bondo it.
Here we have holes on the ....., not sure what you want to call it. Pillar I think. Its the drivers side, is there any easy way to fix that or am I screwed there?
This is under the car looking at the drivers side floor board as it goes up around. Hard to tell I know. Not sure what to do here either
Here in a pic of the drivers side rocker where it connects to the fender. I have a hole where the tape is.
If you guys have any ideas that would be great. Thanks again
Supreme Member
U are going to have filler on the door, and A piller.U want to try to pull the dent out as much as u can first. Than just have a thin coat of filler.same with piller if u put new metal in. The right way to fix rust is cut it out and weld new metal in. U could try por-15 and stuff like that. Have not used it but heard its great. But I still think the only way to fix rust is cut it out and put new metal in.