WTB: SLP 51002 Camshaft
Thread Starter
Junior Member
Joined: Dec 2020
Posts: 6
Likes: 12
Car: 1988 Trans Am GTA
Engine: 5.7L TPI (L98)
Transmission: TH-700R4 (MXO)
Axle/Gears: 3.27:1 (GW6)
WTB: SLP 51002 Camshaft
Looking for a genuine SLP camshaft part number 51002. I would prefer NOS but would accept a low mileage, within spec example.
Thanks
Thanks
Junior Member
Joined: Oct 2004
Posts: 43
Likes: 1
From: New Port Richey, FL
Car: 02 UltraZ, 85 Z28, 98 WS6, 86 Vette
Engine: LS1, SBC 383, LS6, LS2, LQ9
Transmission: T-56, TH400, 4L60E,
Axle/Gears: 3.42s, 3.73s, 4.10s
Re: WTB: SLP 51002 Camshaft
What are your other mods? L98? I'm planning to use a zz4 cam or similar depending how much head work i do to the iron vortec heads I'm using on my build. I've Siamese'd the factory tpi system and am using LSX springs with comp 787 locks for more lift vs the .480 max factory lift. I'm hoping to just reach the 300whp or more via all the porting. Finding the good aftermarket tpi parts especially from SLP are hard and very pricy from what I've seen. The cam I'm going for is $170 shipped from a reputable regrind shop. Otherwise, for $35 I pulled a nice, clean cam from an 97 bird at LKQ. Which i was going to use had i not ported the top end.
good luck
good luck
Joined: Oct 2001
Posts: 12,228
Likes: 1,156
From: Il
Car: 1989-92 FORMULA350 305 92 Hawkclone
Engine: 4++,350 & 305 CIs
Transmission: 700R4 4800 vig 18th700R4 t56 ZF6 T5
Axle/Gears: 3.70 9"ford alum chunk,dana44,9bolt
Re: WTB: SLP 51002 Camshaft
Thread
Thread Starter
Forum
Replies
Last Post








