does anyone know who makes bolt-on headers that don't have the A.I.R. tubes on them,? a guy in my f-body club has some...i think they are MAC headers but not sure...does anyone knwo of anybody that makes them? I am looking for 1 5/8" primaries and a 3" y-pipe. thanks.
-brian

------------------
1991 Camaro RS
----------------------------------------------
Ultra Blue Metallic, T-Tops

GM 350 HO Crate Engine - Vortec Heads, Edelbrock Performer Vortec Intake, Holley 670 CFM Throttle Body, Open Air Cleaner w/14"x3" K&N, Edelbrock TES Headers, Edelbrock Victor Series Water Pump, Accell Superstock Wires, Cap, and Rotor, MSD Blaster Coil, Hypertech Fan Switch & Thermomaster Chip, AC Delco Rapidfires, 3" Cat Back, Flowmaster 40 Series Muffler

700R4 - 2,400 Stall Converter, Vette Servo, Shift Kit, B&M Super Cooler

Brian's 1991 RS

Central NY F-Body Association

Howdy there, I ordered mine from SLP to replace my long tube tri-y headers, they are Off Road headers intended only for racing, I don't remember if they had the 1 5/8" in off road size or not, since I was looking for the 1 3/4". But you can go to www.slponline.com to check it out for yourself, they should be about half way down in the internet specials area if I remember correctly. They are cheaper than the ones with a.i.r. tubes and they include the Y pipe with them. Hope this helps ya out some, take care now

sweet man, thanks a lot

------------------
1991 Camaro RS
----------------------------------------------
Ultra Blue Metallic, T-Tops

GM 350 HO Crate Engine - Vortec Heads, Edelbrock Performer Vortec Intake, Holley 670 CFM Throttle Body, Open Air Cleaner w/14"x3" K&N, Edelbrock TES Headers, Edelbrock Victor Series Water Pump, Accell Superstock Wires, Cap, and Rotor, MSD Blaster Coil, Hypertech Fan Switch & Thermomaster Chip, AC Delco Rapidfires, 3" Cat Back, Flowmaster 40 Series Muffler

700R4 - 2,400 Stall Converter, Vette Servo, Shift Kit, B&M Super Cooler

Brian's 1991 RS

Central NY F-Body Association