replacing rear defogger wires/connectors
Thread Starter
Senior Member
Joined: Mar 2003
Posts: 966
Likes: 2
From: NE Ohio
Car: 83 Z28
Engine: 305 (LG4)
Transmission: THM700R4
Axle/Gears: 10 bolt, 3.23 non-LS
replacing rear defogger wires/connectors
I would be interested in how people restored/replaced the wires and connectors for the rear window defogger. The ones that connected to the rear window struts near the lower pivot point. Every car i have seen has the coating on those wires disintegrated. Mainly I would like to know where to get female blade connectors like those.
thanks in advance.
phil
thanks in advance.
phil
Member
iTrader: (1)
Joined: Jun 2009
Posts: 263
Likes: 0
From: Pennslyvania
Car: 1984 camaro Z28
Engine: 355 SBC
Transmission: 700 r-4
Axle/Gears: Strange 3:73 posi
Re: replacing rear defogger wires/connectors
Hey Phess have you gotten info about the wires yet I just replaced my rear hatch struts and found my wires were falling apart and after searching here and Camaro forum and this is the first post I've seen for this let me know if you have any info.Thanks
Thread Starter
Senior Member
Joined: Mar 2003
Posts: 966
Likes: 2
From: NE Ohio
Car: 83 Z28
Engine: 305 (LG4)
Transmission: THM700R4
Axle/Gears: 10 bolt, 3.23 non-LS
Re: replacing rear defogger wires/connectors
I just bought new braided wire with a black plastic coating and used standard blade connectors from Autozone.
Last edited by phess11; Jun 24, 2009 at 06:33 PM.
Thread
Thread Starter
Forum
Replies
Last Post
