Third Generation F-Body Message Boards

Third Generation F-Body Message Boards (https://www.thirdgen.org/forums/)
-   Electronics (https://www.thirdgen.org/forums/electronics/)
-   -   Error Code 42 (https://www.thirdgen.org/forums/electronics/291496-error-code-42-a.html)

Pdiminico 04-16-2005 12:03 PM

Error Code 42
 
Need help trouble shooting a code 42. This is an 88 TBI engine. While in park or in motion car will begin to stall and the check engine light comes on.

Thanks

Mcdamit 04-16-2005 12:53 PM

42. Fault at electronic spark timing circuit OR
Fault at direct ignition system OR
Fault at fuel cutoff relay circuit

Mcdamit 04-16-2005 12:54 PM

42. Fault at electronic spark timing circuit OR
Fault at direct ignition system OR
Fault at fuel cutoff relay circuit
good luck check your distributor they tend to go bad

Trickster 04-16-2005 01:20 PM

1 Attachment(s)
I have posted this in the past and will post it again. Hope this helps, an item that you might want to cjeck here is the ignition control module.

Trickster 04-16-2005 01:20 PM

1 Attachment(s)
page 2:D

Mcdamit 04-16-2005 02:36 PM

it shouldn't display the code for the icm, mine didn't, I actually am running code 42 right now because my timing is off just check your distribution components

Trickster 04-16-2005 09:53 PM

It would show a code 42 if you had a short to pin "D" of the ICM.:D

Mcdamit 04-17-2005 08:39 PM

yeah that i learned today, but if it isn't working properly it wont if he is starting and stalling..........

iansane 04-18-2005 03:06 AM

You'll also show a 42 if the EST connector is disconnected for you to set the base timing and you forget to plug it back in. :D Ask me how I know.

Pdiminico 04-18-2005 08:00 PM

Error Code 42
 
The code 42 is intermittent and I have already replaced the pickup coil and the ICM. The EST connector is connected. The car starts to stall, comes back to life and kicks on the SES light. I only find the 42 in the ECM and not sure how to start trouble shooting. I cannot reproduce the problem at will.

Pdiminico 04-20-2005 08:42 PM

ECM
 
Swapped out my ECM and the issue seems to be resolved.

Trickster 04-21-2005 10:02 AM

Re: ECM
 

Originally posted by Pdiminico
Swapped out my ECM and the issue seems to be resolved.
Step 5 of the trouble shooting chart posted above.!!!:D


All times are GMT -5. The time now is 11:53 PM.


© 2024 MH Sub I, LLC dba Internet Brands