H4 conversion question
 

I'm sure this has been asked a million times, but after hours of searching I can't seem to find anyone with the same problem. Here's the deal: I've installed actual HID low beams(ones with the ballast) and H4's in the high beams. When I switch to the High Beams, they are really dim and yellow. Its my understanding that they are not receiving enough wattage. I believe they are the 55/65w style. Are there relay kits to correct this? My low beams work perfectly BTW.

Re: H4 conversion question
 

take a look over at this thread to double check your wiring; you may just need to switch a couple of pins around:

https://www.thirdgen.org/forums/body...eadlights.html

Re: H4 conversion question
 

ya the pos and neg are switched around

Re: H4 conversion question
 

Where did you get your HID kit from and do you have any links of the car with them installed?

Re: H4 conversion question
 

Actual,y all the pins are moved 1 spot clockwise for H4 when looking at the back of the bulb if this is the back of the bulb: |_| in that conf. normally it's gnd| _high beam_ |low beam

H4 = high beam| _low beam_ |gnd