|
Stock water temp gauge problem? Had a needle sticking on the temp gauge so I took apart the bezel and freed the needle. Turned the ignition to key on but did not start the car and you could see the needle move a bit and settle into the bottom 100 degree part of the gauge so I knew it was getting power. As soon as the car is started the needle instantly pegs. I have a new sensor but haven't tried it yet. That will be my next step but was just wondering what everyone thinks could be causing this? Thanks! |
Re: Stock water temp gauge problem? I would try the new sensor |
Re: Stock water temp gauge problem? Sounds like the wire is disconnected and laying against something metal. (shorted to ground) Sending unit (not really a "sen-sore" [/mr.spock]) might be fine... try hooking the wire up right. |
Re: Stock water temp gauge problem?
Originally Posted by sofakingdom
(Post 5944478)
Sounds like the wire is disconnected and laying against something metal. (shorted to ground) Sending unit (not really a "sen-sore" [/mr.spock]) might be fine... try hooking the wire up right. |
Re: Stock water temp gauge problem? I guess I assumed something that simple would have been checked Then on what basis did you make this a$$-u-me mistake? ;) |
Re: Stock water temp gauge problem?
Originally Posted by sofakingdom
(Post 5944505)
Did you check it? Then on what basis did you make this a$$-u-me mistake? ;) |
Re: Stock water temp gauge problem? 1 Attachment(s) |
Re: Stock water temp gauge problem? :lol: :lmao::yup: :goodjob: :eek: :thanks: :totopic: Mang the smilies are a BEOTCH these daze.... |
| All times are GMT -5. The time now is 11:24 PM. |
© 2024 MH Sub I, LLC dba Internet Brands