NOS accel base
 

Unused accel base. Also have the nos super ram upper if anyone is interested.

700 + trip + paypal fees or meet up to 2hr from nashville

https://cimg1.ibsrv.net/gimg/www.thi...f6da416efc.jpg
https://cimg4.ibsrv.net/gimg/www.thi...ff69c27f02.jpg
https://cimg7.ibsrv.net/gimg/www.thi...f96042724d.jpg
https://cimg8.ibsrv.net/gimg/www.thi...5d96481d90.jpg

Re: NOS accel base
 

This is I believe casted by buddy barr, not the later edelbrock casting

Re: NOS accel base
 

Yes this is an original Accel/Lingenfelter high flow TPI intake manifold base cast by (BB) Buddy Bar and used with the Accel/Lingenfelter StreetRam & SuperRam induction system.

The ones cast by Buddy Bar have the Accel logo further back on the manifold close to the middle on the runners feeding cylinders 2 & 4. The later ones cast by Edelbrock have the Accel logo up front on the runners feeding cylinders 1 & 3.

Re: NOS accel base
 

I did not know that fact. Had to grab my Accel intake from storage to check it and it has the logo close to cyl 2 & 4.

Good Luck on the sale CamG813.

Fred

Re: NOS accel base
 

Sold with the Super Ram upper

Re: NOS accel base
 

Now that it is sold I want to ask a question. For the life of me I can't remember what screws into the four threaded holes between the injector bosses that you have the hex head bolts threaded into in the pics. Do you know what goes into them?

Re: NOS accel base
 

the small holes that are threaded by the injector boss were for studs to hold the wiring hardness on c4 vettes.