When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
From: Franklin, KY near Beech Bend Raceway, Corvette Plant and Museum.
Car: 1992 Pontiac Firebird
Engine: 5.0L L03 TBI
Transmission: 700R4
Axle/Gears: 2.73
Re: NOS accel base
Yes this is an original Accel/Lingenfelter high flow TPI intake manifold base cast by (BB) Buddy Bar and used with the Accel/Lingenfelter StreetRam & SuperRam induction system.
The ones cast by Buddy Bar have the Accel logo further back on the manifold close to the middle on the runners feeding cylinders 2 & 4. The later ones cast by Edelbrock have the Accel logo up front on the runners feeding cylinders 1 & 3.
Yes this is an original Accel/Lingenfelter high flow TPI intake manifold base cast by (BB) Buddy Bar and used with the Accel/Lingenfelter StreetRam & SuperRam induction system.
The ones cast by Buddy Bar have the Accel logo further back on the manifold close to the middle on the runners feeding cylinders 2 & 4. The later ones cast by Edelbrock have the Accel logo up front on the runners feeding cylinders 1 & 3.
I did not know that fact. Had to grab my Accel intake from storage to check it and it has the logo close to cyl 2 & 4.
Good Luck on the sale CamG813.
Fred
Last edited by Fred SS; Apr 28, 2024 at 05:00 PM.
Reason: Correct post
From: Franklin, KY near Beech Bend Raceway, Corvette Plant and Museum.
Car: 1992 Pontiac Firebird
Engine: 5.0L L03 TBI
Transmission: 700R4
Axle/Gears: 2.73
Re: NOS accel base
Now that it is sold I want to ask a question. For the life of me I can't remember what screws into the four threaded holes between the injector bosses that you have the hex head bolts threaded into in the pics. Do you know what goes into them?
Now that it is sold I want to ask a question. For the life of me I can't remember what screws into the four threaded holes between the injector bosses that you have the hex head bolts threaded into in the pics. Do you know what goes into them?
the small holes that are threaded by the injector boss were for studs to hold the wiring hardness on c4 vettes.
