Third Generation F-Body Message Boards - Cylinder head mounting template

Third Generation F-Body Message Boards (https://www.thirdgen.org/forums/)

- Fabrication (https://www.thirdgen.org/forums/fabrication/)

- - Cylinder head mounting template (https://www.thirdgen.org/forums/fabrication/734802-cylinder-head-mounting-template.html)

anesthes

07-05-2016 02:51 PM

Cylinder head mounting template

Hello,

Wasn't sure if anyone knew where I could download a printable template of the accessory mounting positions on SBC cylinder heads.

I can make one out of cardboard, but I'd rather have one that was done in CAD or something that's 100% dead on.

-- Joe

Tibo	07-09-2016 10:09 AM

Re: Cylinder head mounting template

I had a similar issue once so I went out and bought the harbor freight set of transfer punches and then a transfer screw set also. They work great. I thought you engineers all had a magic drawer where you could pull out any precise tool you wanted- just like a magician's hat.

http://www.harborfreight.com/28-piec...-set-3577.html
http://www.ebay.com/itm/7-PIECE-TRAN...QAAOSwo6lWITJC

anesthes

07-11-2016 09:46 AM

Re: Cylinder head mounting template

Quote:

Originally Posted by Tibo (Post 6057232)

Thanks, I'll give that a try.

I'm not a mechanical engineer, no magic tool box. :)

Thanks

-- Joe

Twin_Turbo

07-11-2016 10:16 AM

Cylinder head mounting template

Uhm factory drawing from power manual? Or do you need a complete engine? Grabcat has some

anesthes

07-11-2016 11:59 AM

Re: Cylinder head mounting template

Quote:

Originally Posted by Twin_Turbo (Post 6057808)

Uhm factory drawing from power manual? Or do you need a complete engine? Grabcat has some

Grabcad ? I'll check it out. Thanks.

-- Joe

All times are GMT -5. The time now is 02:34 PM.