Third Generation F-Body Message Boards

Third Generation F-Body Message Boards (https://www.thirdgen.org/forums/)
-   TBI (https://www.thirdgen.org/forums/tbi/)
-   -   Got an odd one (https://www.thirdgen.org/forums/tbi/655632-got-odd-one.html)

2kickassbirds 06-28-2012 08:59 PM

Got an odd one
 
So I just got a 91 firebird l03 auto the car idles fine but when I hit the gas the ses comes on and runs bad like it is missing. Then in 2 seconds or so the light goes away and runs fine, as you drive it goes back and forth.
So I have checked
Timing @ o
Fuel psi 14
Tps .58-4.48
Map, iac,esc,icm,air temp and all grounds are good
And I can not pull a code both my scan tool will not link and when I jump it I get me no codes
O and it has a jet stag 2 in it and the car is all stock

Any input would be helpful thanks Tyler

RFmaster 06-29-2012 12:58 AM

Re: Got an odd one
 
Check fuel pressure during idle and while it is stumbling. If the fuel pressure remains steady this would rule out fuel delivery issues for the most part. The other possibility is a bad dizzy - reluctor coil is intermittent or a stator has loose magnet. Pop the cap off and see if the base very rusty looking. Moisture accumulation inside dizzy is common due to clogged vents. Most of the times swapping in a rebuilt unit cures these mysterious stumbles, loss of power...

//RF

Camaro-Drew 07-06-2012 01:57 PM

Re: Got an odd one
 
My camaro had this same exact problem, couldn't figure it out for the life of me. I ended up taking it to the dealer (been a diesel mechanic for over a decade so it was real hard to admit to myself I couldn't figure it out, swallowed my pride and took it in), they diagnosed it as a bad distributer. So I took it home and dropped in a brand new MSD unit, still same exact problem. (stupid dealership mechanic's, paid for a diagnosis and they just guess) I ended up going a totally different direction with the car, threw away the 305 and gutted the electronics (in the process of turning into a track only drag car) To this day that problem puzzles me and I still wonder what it could have been...Hope you find the answers, I'll be watching this closely!!

p/s: this was a few years back, wish I would've known about 3go at the time!!

UnderCover89TBI 07-06-2012 06:12 PM

Re: Got an odd one
 
bad ground for ecm. bad ecm. distributor. hard to be 100% sure.

Schurkey 07-07-2012 11:29 PM

Re: Got an odd one
 

Originally Posted by 2kickassbirds (Post 5314153)
And I can not pull a code both my scan tool will not link

I'd think that is a clue in itself.

ALDL mis-wired?

SES light bulb burned out?

I'd be checking everything in the ALDL circuit.

2kickassbirds 07-09-2012 04:14 PM

Re: Got an odd one
 
it was the tps my meater coulod not read it but it was jumping back to .35 when at part open. thanks guys


All times are GMT -5. The time now is 08:26 PM.


© 2024 MH Sub I, LLC dba Internet Brands