Engine/ Cam Break In? So I am completly rebuilding a L98. Intake mods and a crane cam 2032. What break in should I do? Any special fluids I should use? Thanks in advance:thanks: |
Re: Engine/ Cam Break In? ins't that a roller cam, no need to break it in !! |
Re: Engine/ Cam Break In? it is, but i mean the engine as a whole? changed all the rings ect... had to stripped down to the bare block andthing that has the ability to naturally wear and tear has been replaced. i mean i cant just drop the engine in and drive it down to the track right? |
Re: Engine/ Cam Break In? I allway use gm eos on a new rebuild or a high zinc. and use a oil primer, Im cheap and just ground off the teeth off a old distributor. |
Re: Engine/ Cam Break In? that just gets added into the oil? will i have to do an oil change sooner then 3000? Going to use synthetic... |
Re: Engine/ Cam Break In? yes add it to the oil!, I ussually change the oil after a couple warm up cycles and timing adjustment, change the oil and run synthetic maybe around the 3k mark. |
All times are GMT -5. The time now is 01:18 AM. |
© 2024 MH Sub I, LLC dba Internet Brands