|
Sending Unit Removal... 1 Attachment(s) HOW THE F*&#@ DO I GET THIS OUT?!?!?!? |
Re: Sending Unit Removal... The two tabs sticking up are part of a lock ring that holds it in. Take a hammer and a flat screwdriver and peck them around counterclockwise. You will have to alternate from one tab to the other because it will drive the ring to one side when you work it around and bind it. |
Re: Sending Unit Removal...
Originally Posted by Joe Tag
(Post 5809033)
The two tabs sticking up are part of a lock ring that holds it in. Take a hammer and a flat screwdriver and peck them around counterclockwise. You will have to alternate from one tab to the other because it will drive the ring to one side when you work it around and bind it. |
Re: Sending Unit Removal... Looks like it's cut out from the tank? Use some penetrating oil on it. Clamp the sheet metal in a vise so you have it stabilized and can put some torque to it. If that fails drill out a few of the spots holding the outer ring to the "tank" and pry that ring away from the lock ring. You don't want to beat up the sender. |
Re: Sending Unit Removal... i had it were it was binding did u press the tabs down also you can pop one side out and then pull it off from there if that fails get some tin snips and cut it |
Re: Sending Unit Removal...
Originally Posted by aramirez121
(Post 5809400)
i had it were it was binding did u press the tabs down also you can pop one side out and then pull it off from there if that fails get some tin snips and cut it |
| All times are GMT -5. The time now is 07:50 AM. |
© 2024 MH Sub I, LLC dba Internet Brands