converter keeps spinning Im trying to take the bolts off my converter but they're on super tight. i can get to the bolts fine its just they're on so tight the converter just spins. any way to lock it in place or good tips. ( i've done it before, my uncle just really cranked down on the bolts last time we swapped tranny's) |
Re: converter keeps spinning Hold the ring gear with a large flat tip screwdriver. |
Re: converter keeps spinning i wedged the lever for the stock jack into the teeth of the flex plate. worked fine for me |
Re: converter keeps spinning Don't be cheap with purchasing tools. Go Buy a flexplate wrench and do it correctly. It will save your hands,knuckles and having to replace the flexplate when you have a snafu and break off the flexplate starter ring teeth. There just isn't any substitutions here --- unless your very lucky---, that usually happens only a few times. Good flexplate wrenches start at under $50.00 and go on up to $100.00 . You won't be sorry on buying one. You will use it more than you know. Red Loctite the converter bolts only a couple threads when going back together... this is a plenty. |
Re: converter keeps spinning thanks i was looking for same answer .i did not know there was a wrench for it i will go buy one . |
Re: converter keeps spinning Also, warm the bolts with a propane torch for a few minutes. This will soften the locktite that is on the threads. |
Re: converter keeps spinning I'm new.... I just signed up for this forum. My son and I bot a 83 Z28 IROC camaro. Don't know much about it. It runs and drives except yesterday the reverse stopped working... any ideas what that problem would be? |
Re: converter keeps spinning Welcome to the forum! Reverse seldom fails, but when it does, it is usually internal. I assume we are talking about an auto trans? Please start a new thread for assistance on your problem. You will get more replies, and it is also a bit more polite than to piggyback it on someone else's thread. |
Re: converter keeps spinning Sorry, I don't know how to use this forum...I figured some one would eventually ream me.... :-) |
All times are GMT -5. The time now is 05:23 AM. |
© 2024 MH Sub I, LLC dba Internet Brands