[TX] Need passenger fender and hood
Thread Starter
Supreme Member
Joined: Jan 2007
Posts: 1,002
Likes: 12
From: Bastrop, TX
Car: 1988 SC Convertible
Engine: LT-1
Transmission: 700R4
Axle/Gears: 3.23 posi w/PBR's
Need passenger fender and hood
I'm looking for any factory hood for a Firebird/Formula/TA/GTA and a passenger fender WITHOUT the vent.
The straighter the better.
I'm in the middle of Texas.
The straighter the better.
I'm in the middle of Texas.
Member
iTrader: (6)
Joined: Apr 2013
Posts: 385
Likes: 0
Car: 91 ws6
Engine: Carb'd 334 stroker
Transmission: T5
Re: Need passenger fender and hood
Were you wanting local only, or shipping an option?
I have a pass fender without vent that I pulled off my 87. Its either lightly painted, or was primed black just to keep away rust, has no GFX on it, it was a new fender. I put it up in my attic a few years ago, so should still be good to go, had zero rust, pretty nice condition. Would be from middle KS tho
Asking $150+ shipping.
I have a pass fender without vent that I pulled off my 87. Its either lightly painted, or was primed black just to keep away rust, has no GFX on it, it was a new fender. I put it up in my attic a few years ago, so should still be good to go, had zero rust, pretty nice condition. Would be from middle KS tho
Asking $150+ shipping.
Last edited by dixie wrecked; Dec 3, 2017 at 04:56 PM.
Joined: Jan 2002
Posts: 1,434
Likes: 6
From: Dallas
Car: 1982 Trans Am KITT Replica
Engine: LU5 305 CROSSFIRE
Transmission: TH-350
Axle/Gears: Limited Slip 3:23
Re: Need passenger fender and hood
