i wsa reading this past months CHP, and they installed an ES torque arm bushing on the car and seemed to get a good response. Has anyone else tried these? thanks

Yup. Piece of cake. Just grind or drill out those big rivets, clean up the mount, and install the new bushing. Grease it up good.

Here's a pic and a link to my rebuild page. I cover the install in detail.

Ed

http://photos.yahoo.com/bc/taramille...tos.yahoo.com/

thanks, did u notice any track improvments with it (i.e. 60ft)

I've never run my car down a track, but it reduced the "slam" when I put it into gear. It's a good piece to replace.

Ed