E36 headlight conversion done
05-22-2015, 10:39 PM
#2
Junior Member
iTrader: (-1)
Join Date: Mar 2015
Location: West By God Virginia
Posts: 31
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1986 Z28 Iroc
Engine: 350
Transmission: 700r4
Axle/Gears: 3.23
Re: E36 headlight conversion done
Very nice. I'm going to do that myself very soon. I think the stock 3rd gen lighting is horrible. Did you follow the write up on here? Any more pics of the install?
05-23-2015, 08:53 AM
#3
Member
Thread Starter
Join Date: Jun 2010
Location: Holly Springs NC
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1988 iroc
Engine: 350 30 over
Transmission: T5
Axle/Gears: Series 2 373
Re: E36 headlight conversion done
ill post some other pic later
these are the US version E36 not the projector style, Im not cutting the radiator supports. i just cut the headlight buckets out of the fiberglass support and made brackets to mount the e36 headlights snd added angle eyes to the headlights
these are the US version E36 not the projector style, Im not cutting the radiator supports. i just cut the headlight buckets out of the fiberglass support and made brackets to mount the e36 headlights snd added angle eyes to the headlights
08-04-2015, 06:50 AM
#4
Junior Member
Join Date: May 2015
Location: MA
Posts: 57
Likes: 0
Received 0 Likes
on
0 Posts
Car: 82 Trans AM Firebird
Engine: JASPER 350
Transmission: Swapped WC T5
Re: E36 headlight conversion done
Don't deal with Buloushie, This scum bag ripped me off. Hes going to take the money that he stole from me and buy a part from you. If he even pays you. This is fair warning for anyone dealing with this piece of sh*t.
08-04-2015, 08:10 AM
#5
Member
Thread Starter
Join Date: Jun 2010
Location: Holly Springs NC
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1988 iroc
Engine: 350 30 over
Transmission: T5
Axle/Gears: Series 2 373
Re: E36 headlight conversion done
Not really I set the headlights in after cutting the headlight buckets back
Then fab a top and bottom bracket up to hold in position
Then fab a top and bottom bracket up to hold in position
Thread
Thread Starter
Forum
Replies
Last Post