bholmes

What about the felt pieces that go on outside of doors against the door windows

MantyZ28

iTrader: (16)

no good window sweeps

MantyZ28

iTrader: (16)

bump

MantyZ28

iTrader: (16)

bump

ThirdGen1984

iTrader: (1)

Knee Bolster for 1984 Camaro(black) and 1984 Camaro shift ****(the round one and black)

MantyZ28

iTrader: (16)

no I don't have much of that early stuff left

2012sergen11

iTrader: (1)

Air intake ducting for tpi engine?

MantyZ28

iTrader: (16)

I may have that do you have a picture of what yours looks like?

MantyZ28

iTrader: (16)

bump

FED 387

looking for a Camaro dash pad---no damage !!!!!

MantyZ28

iTrader: (16)

don't have one

jnman

Color (black needed) & Shape of drivers side door sill and cost shipped to 70611??

AmpleUnicorn88

Any 305 parts? It may also be the same as on the 350, but I am not positive on that. I am looking for the intake manifold vacuum fitting that sits on top of the back end of the intake manifold. It's a little piece that screws into the manifold and it makes a 90* bend. Also looking for a shifter plate for a 5spd manual camaro, preferably with the lettering still intact and white. Headliner in good condition dark grey or black.

MantyZ28

iTrader: (16)

AmpleUnicorn88 I do not have that 90 degree bend piece I keep selling it with all my motors and I don't have a 5 speed shift plate yet


JNMAN PM sent

ThirdGen1984

iTrader: (1)

wheels?

MantyZ28

iTrader: (16)

not much left at the moment

jredelk

steering wheel?

MantyZ28

iTrader: (16)

what do you want it to fit? I got a firebird one left

MantyZ28

iTrader: (16)

and one off an 87 camaro

yankeecarman

iTrader: (9)

Do you have horn button switches for a 1991 Firebird? thanks.

MantyZ28

iTrader: (16)

no that I know of just got an 89 bird in but its got an aftermarket wheel on it or if you have a pic of exactly what your talking about I can double check

yankeecarman

iTrader: (9)

From what I understand the buttons only came in 90 or 91-92. Im sure it would not be on an aftermarket wheel. Thanks anyway.

MantyZ28

iTrader: (16)

I have a factory wheel off an 88 but since you said 91-92 then I wouldnt have it

ktthecarguy

hi there,
Do you have a center console armrest pad?

AaronIROCZ

iTrader: (5)

Tilt steering column?? I don't care on options or for a Camaro or Firebird just as long as the plastics are not broken. My plastics are broken up and will swap my good parts over to the other. Thanks!!

MantyZ28

iTrader: (16)

no I don't just sold my last one

MantyZ28

iTrader: (16)

ill look at what I got left for columns

MantyZ28

iTrader: (16)

bump

MantyZ28

iTrader: (16)

bump!!!!

dbrochard

iTrader: (3)

I need a drivers side grey leather 89-92 door panel. Condition of the cardboard backing does not matter

MantyZ28

iTrader: (16)

I dont have anything in leather

Ikes 91Z

iTrader: (1)

Do you have an HVAC Wiring harness from a 90-92?

MantyZ28

iTrader: (16)

nope sold out apparently I should get a few more 90-92 cars!!!

ktthecarguy

Hi there,
Any front seat belt receivers available? I am looking for front driver side. but I think either side will work. I am looking for red (highly unlikely, I know) or grey or tan. Black might be too dark, too hard for me to vinyl dye to red.

Also looking for the driver seat track covers, the black plastic pieces.

Also I need 3 of the square plastic blocks that hold the rear interior trim pieces in place. the blocks that the big plastic screws screw into. Also need 3 screws, any color.

Any luck with any of these?

MantyZ28

iTrader: (16)

I should have that pm me your email I'' send you some pics

cmk-2

iTrader: (1)

Looking for a Black folding rear storage hatch, With or without the Bose speakers. Would like without speakers

MantyZ28

iTrader: (16)

I do not have one of those

MantyZ28

iTrader: (16)

Bump

Fireslash

Automatic shifter unit with connector witha few inches of wire left on the connector, auto shifter plate, auto pedals?

bholmes

Anything on door panels yet? Black in color, 1987 iroc. Also have question: my 3td brake light is in rear spoiler and doesn't work, the light itself works but doesn't work when hatch is closed! Any help would.greatly appreciated

MantyZ28

iTrader: (16)

I have no door panels yet but if you still need window sweeps pm me your email I did get some and sounds like you have a wire issue like a pinched wire or something along those lines

MantyZ28

iTrader: (16)

bump

ThirdGen1984

iTrader: (1)

looking for a RAII hood for a camaro

MantyZ28

iTrader: (16)

don't have one

ANDYZ28

I need an early (non-air bag) steering column. Not the lower portion, but the part that goes into the car. Do you have one?

MantyZ28

iTrader: (16)

like the part where the wheel bolts too? is yours tilt?

ANDYZ28

yes, TILT TOO.

MantyZ28

iTrader: (16)

im all sold out of columns except for one that is non tilt currently

Goodolboy0404

5 speed shifter plate for 87 camaro in good shape?

MantyZ28

iTrader: (16)

all my shift plates both auto and manual are sold out for now