Prep for adding peal & seal
04-19-2005, 10:13 AM
#1
Member
Thread Starter
Join Date: Sep 2001
Location: South Texas
Posts: 456
Likes: 0
Received 1 Like
on
1 Post
Car: 97 200sx se-r, 82 Trans/Am
Engine: 350 bored to 355
Transmission: 700r4
Axle/Gears: 9 bolt 3.45
Prep for adding peal & seal
What kind of prep work should I do before I use peal and seal on the floorboards. I am worried about rusting under the tar. I guess sanding, priming, and then rustoleum coating would be the best method, right? After that, use a heat gun and a roller, right?
I don't want to spring for dynamat, so peal & seal it is. I will let the car air out prior to driving it.
Jay
I don't want to spring for dynamat, so peal & seal it is. I will let the car air out prior to driving it.
Jay
04-19-2005, 11:50 AM
#2
Senior Member
Join Date: Dec 2000
Location: Topeka
Posts: 638
Likes: 0
Received 0 Likes
on
0 Posts
Make sure you have a clean rust free surface and I would put a few coats of primer on anything that needs repainted. You could also look at some latex based deadeners like the V3
Thread
Thread Starter
Forum
Replies
Last Post
1Aauto
Sponsored Vendors
9
10-19-2016 08:50 AM
Bohemian
Aftermarket Product Review
11
11-25-2015 09:38 PM
1Aauto
Sponsored Vendors
1
10-13-2015 03:06 PM
Dragonsys
Engine/Drivetrain/Suspension Parts for Sale
2
09-25-2015 03:51 PM