Accel DFI Gen 7 wiring question
03-03-2006, 09:47 AM
#1
Junior Member
Thread Starter
Join Date: Mar 2006
Location: Campbell, CA
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Car: 70 vette roadster
Engine: 383
Transmission: tremec 5spd
Axle/Gears: 3.73
Accel DFI Gen 7 wiring question
I'm installing a gen 7 system for an inductive pick up ignition. I can't figure out how to wire it for my MSD distributor(8571) and a 6T ignition box . The wiring diagrams from Accel aren't clear on this. Can anyone help?
03-06-2006, 06:09 AM
#2
Member
Join Date: Dec 2001
Location: Michigan
Posts: 161
Likes: 0
Received 0 Likes
on
0 Posts
Car: GTP
Engine: L67
Crank position output from MSD (Purple & Green ???) wires go to CRK+ and CRK - on the DFI, use the Blue EST output from the Gen 7 to trigger your ignition box. Press CTRL-F1 from your DFI software to get to a drawing of the main wire harness. Make sure your DFI is programmed correctly for the IPU input and whatever output the ignition box requires.
03-06-2006, 11:29 AM
#3
Junior Member
Thread Starter
Join Date: Mar 2006
Location: Campbell, CA
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Car: 70 vette roadster
Engine: 383
Transmission: tremec 5spd
Axle/Gears: 3.73
Thanks for the help! So the blue EST wire goes to the white wire on the MSD box. Do you know what the pink wire does? The wiring diagram shows it as "flying lead 2 VIGT".
-Bob
-Bob
Thread
Thread Starter
Forum
Replies
Last Post
