WinBin question
#1
Thread Starter
TGO Supporter
iTrader: (1)
Joined: Jan 2003
Posts: 371
Likes: 0
From: Chicago area
Car: 87 Z-28
Engine: 383 HSR w/supercharger, AFR heads
Transmission: 700r4 w/2500 stall
Axle/Gears: 3:73
WinBin question
I just downloaded WinBin. My intent is to use it on a 1227165 ECM (87 TPI w/MAF). I can't get the program to work. It asks me to select a BIN file on the first screen. What is this file?
I previously downloaded WinALDL and that works just fine.
I previously downloaded WinALDL and that works just fine.
#2
The BIN file is the BINary file you're going to edit with Winbin. It is the program that you are going to burn onto the EPROM with your prom programmer when you have edited it.
There are BINs on the DIYEFI site. You'll also need the correct .ECU file for the mask for your ECM to allow Winbin to interpret the binary into English.
John
There are BINs on the DIYEFI site. You'll also need the correct .ECU file for the mask for your ECM to allow Winbin to interpret the binary into English.
John
#3
TGO Supporter
Joined: Jan 2000
Posts: 1,861
Likes: 0
From: In your ear. No, the other one.
Car: '89 Trans Am WS6
Engine: 350 TPI
Transmission: T5WC
Axle/Gears: 3.08 posi
give <a href = "http://www.markmansur.com/gmecmedit/">GMECM Edit</a> a try. its as good (or better) than winbin, and uses the same ECU files.
Last edited by Mangus; 03-23-2003 at 03:22 PM.
Thread
Thread Starter
Forum
Replies
Last Post