Fuel relay
03-16-2012, 11:06 AM
#1
Member
Thread Starter
Join Date: Apr 2005
Location: Hamilton ON Canada
Posts: 490
Likes: 0
Received 1 Like
on
1 Post
Car: 87 GTA t-top
Engine: L98 350 w/RMT
Transmission: 700R4
Axle/Gears: 9 bolt BW 3.45
Fuel relay
I was hoping to eliminate the stock fuel relay and use the signal from the computer to my racetronix fuel pump relay but which wire should I use?
I have the A1 (GRN/ WHT) relay wire and the B2 (TAN/ WHT) fuel pump signal from the computer.
This is using the EBL setup and eliminating the MAF relays + if I can the stock fuel relay as well.
I have the A1 (GRN/ WHT) relay wire and the B2 (TAN/ WHT) fuel pump signal from the computer.
This is using the EBL setup and eliminating the MAF relays + if I can the stock fuel relay as well.
03-17-2012, 02:09 AM
#2
Supreme Member
iTrader: (13)
Join Date: Apr 2005
Location: Not in Kansas anymore
Posts: 7,732
Likes: 0
Received 11 Likes
on
11 Posts
Car: 82 Z28
Engine: 383 SP EFI/ 4150 TB
Transmission: T400
Axle/Gears: QP 9" 3.73
Re: Fuel relay
If it is same as stock ; grn/white is the trigger to operate the pump relay
Tan/ white is only feedback ( fuel pump signal) to the ECM showing that pump has voltage available
( and is presumably running )
Typical GM pump wiring ( wire colors vary )
Tan/ white is only feedback ( fuel pump signal) to the ECM showing that pump has voltage available
( and is presumably running )
Typical GM pump wiring ( wire colors vary )
Last edited by vetteoz; 03-17-2012 at 02:13 AM.
Thread
Thread Starter
Forum
Replies
Last Post
