SBC 355 new parts inside
08-05-2006, 11:57 PM
#1
Member
Thread Starter
Join Date: Dec 2003
Location: metrodetroit
Posts: 168
Likes: 0
Received 0 Likes
on
0 Posts
Car: 87gta
Engine: dont know yet
Transmission: 700-r4 race prep
SBC 355 new parts inside
Also have a 355 long block. This lb has Eagle cast crank, Eagle forged rods, Hyper(brand with the lightning bolt, dont remember) pistons, edelbrock truroller timing chain, comp roller bump stick, comp roller lifters. Off brand water pump and cast iron ballancer- not installed but will throw it in!
specs
stroke: 3.48 in, cast steel Eagle new and installed
Rods: 5.7in, forged steel Eagle new and installed
pistons: Speed pro 4.030 with moly rings,-5cc
Block: Used out of my old 87' GTA. Baked and boiled. Bored and honed out using torque plates. Both decks cut to 9in so thats a .025 negitive cut. For a 9 inch deck height. With -5cc pistons this gives you a 10.30:1 compression ratio.
1950.00 in receipts first 1200.00 takes her home. Shipping not included, thats extra.
specs
stroke: 3.48 in, cast steel Eagle new and installed
Rods: 5.7in, forged steel Eagle new and installed
pistons: Speed pro 4.030 with moly rings,-5cc
Block: Used out of my old 87' GTA. Baked and boiled. Bored and honed out using torque plates. Both decks cut to 9in so thats a .025 negitive cut. For a 9 inch deck height. With -5cc pistons this gives you a 10.30:1 compression ratio.
1950.00 in receipts first 1200.00 takes her home. Shipping not included, thats extra.
Last edited by juggernaut_69; 08-19-2006 at 04:32 AM. Reason: not 64cc piston -5cc oops
Thread
Thread Starter
Forum
Replies
Last Post
LT1Formula
Engine/Drivetrain/Suspension Parts for Sale
20
11-14-2015 12:02 AM