FACTORY ROLLER VALVETRAIN PARTS
08-21-2006, 10:11 PM
#1
Member
Thread Starter
Join Date: May 2002
Location: BENSALEM, PA
Posts: 292
Likes: 0
Received 0 Likes
on
0 Posts
Car: 88 FORMULA / 88 IROC
Engine: 355 / 355
Transmission: T5 / TH400
Axle/Gears: 10 Bolt-3.73 / 9"-3.90
FACTORY ROLLER VALVETRAIN PARTS
All parts are for 87-up sbc with factory roller block:
lifter spider hold down with links and cam retainer plate used $35
hydraulic roller lifters used, cleaned and ready for installation $45
package deal also available!
Josh
215-783-4645
lifter spider hold down with links and cam retainer plate used $35
hydraulic roller lifters used, cleaned and ready for installation $45
package deal also available!
Josh
215-783-4645
Last edited by FORMULA355TPI; 09-13-2006 at 07:21 AM.
08-23-2006, 10:37 PM
#3
Member
Thread Starter
Join Date: May 2002
Location: BENSALEM, PA
Posts: 292
Likes: 0
Received 0 Likes
on
0 Posts
Car: 88 FORMULA / 88 IROC
Engine: 355 / 355
Transmission: T5 / TH400
Axle/Gears: 10 Bolt-3.73 / 9"-3.90
you are pretty much right.. you may need a bolt or two but the hard parts are all there..
09-14-2006, 05:42 AM
#5
Junior Member
Join Date: Nov 2005
Location: Rocky Mount , NC
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
Car: 84 Corvette Turbo
Engine: 5.7
Transmission: modified 700r4
So no additional machining is need to install in non-roller block right??? If so Pm me your address. bobbychrry@yahoo.com
09-14-2006, 08:12 AM
#6
Member
Thread Starter
Join Date: May 2002
Location: BENSALEM, PA
Posts: 292
Likes: 0
Received 0 Likes
on
0 Posts
Car: 88 FORMULA / 88 IROC
Engine: 355 / 355
Transmission: T5 / TH400
Axle/Gears: 10 Bolt-3.73 / 9"-3.90
I dont know if it would need machining or not you would have to check with your engine builder if you are unsure. These are all the parts needed for a factory roller cam set up on 87+ blocks.
Thread
Thread Starter
Forum
Replies
Last Post
junkcltr
Tech / General Engine
6
08-02-2019 11:12 PM
IrocZ'85
Engine/Drivetrain/Suspension Parts for Sale
0
08-17-2015 06:24 PM