[TX] [SOLD] Dyno Dons 1 3/4 Headers with AIR tubes
#1
Junior Member
Thread Starter
Join Date: Jul 2002
Location: DFW, TX
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1990 IROC
Engine: TPiS 383 (440hp/561tq)
Transmission: Built 700R4
Axle/Gears: Strange 3.73 12 Bolt
[SOLD] Dyno Dons 1 3/4 Headers with AIR tubes
Like new 1 3/4 ceramic coated Dyno Dons Headers with AIR tubes. They were test fit but never ran, before I went in a different direction on my car. A few mild cosmetic scuffs on driver side header that would probably buff out. Theyre $660 for the headers new.
$350 OBO, plus $50 for shipping if not local.
Unfortunately, I dont have both y pipes for dual cat setup as one was lost during a move to DFW area. The Y pipes are available separately for single or dual cat setups or you can fab your own.
$350 OBO, plus $50 for shipping if not local.
Unfortunately, I dont have both y pipes for dual cat setup as one was lost during a move to DFW area. The Y pipes are available separately for single or dual cat setups or you can fab your own.
Last edited by feldme; 06-24-2022 at 07:33 AM. Reason: Sold
Thread
Thread Starter
Forum
Replies
Last Post