wanted: v8 t5
#1
wanted: v8 t5
I dont know much about camaros (im a jeep guy) but i bought a camaro with a 305 and a v6 t5 rigged to it, i wanna get rid of this mess because of clutch issues and put a v8 t5 in it, i believe thats 26 splines, email me at brianhoffman_99@yahoo.com, im in the hazleton area pa
#3
Member
Join Date: Jul 2010
Location: Circleville Ohio
Posts: 172
Likes: 0
Received 0 Likes
on
0 Posts
Car: 65 Nova Wagon
Engine: 358
Transmission: 350 turbo
Axle/Gears: 410
Re: wanted: v8 t5
I have a T5 set up
it was in a 91 camaro Rs 112k original miles less then 900 on rebuild
All New seals/syncros/solid input shafts ect (this alone was $950)
Shifter (Stock)
Stock Clutch/pressure plate with some life left
Flywheel for pre 86 motor(2 peice rear main seal)
Id take $850+Shipping
I am in Chillicothe Ohio 45601
I have all the stuff for swap except slave cylinder/fluid resivor/clutch fork(i might have this)
614 364 9995
it was in a 91 camaro Rs 112k original miles less then 900 on rebuild
All New seals/syncros/solid input shafts ect (this alone was $950)
Shifter (Stock)
Stock Clutch/pressure plate with some life left
Flywheel for pre 86 motor(2 peice rear main seal)
Id take $850+Shipping
I am in Chillicothe Ohio 45601
I have all the stuff for swap except slave cylinder/fluid resivor/clutch fork(i might have this)
614 364 9995
#4
Senior Member
Join Date: Nov 2008
Location: Ft Campbell, KY
Posts: 311
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991 Camaro RS/Z28
Engine: 357 Edelbrock Intake & Holley Carb
Transmission: WC T-5
Axle/Gears: whatever stock is
Re: wanted: v8 t5
What do you have right now for your car? I have a T-5WC setup that I swapped in but now I want the 700-R4 back lol. The trans does need a rebuild but the slave cylinder, clutch master cylinder, and clutch setup are brand new. Everything would be up for trade for a complete 700-R4 setup.
Thread
Thread Starter
Forum
Replies
Last Post
Andre#4
Engine/Drivetrain/Suspension Wanted
1
07-27-2011 05:38 PM
Andre#4
Exterior Parts Wanted
3
07-22-2011 12:21 PM