79 350 with 76cc heads LOW COMP.!!!
#1
Junior Member
Thread Starter
Join Date: Sep 2013
Location: Palm harbor,FL
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1990 camaro rs
Engine: LQ4 350 4 Bolt
Transmission: 700r4
Axle/Gears: 4:10 posi
79 350 with 76cc heads LOW COMP.!!!
So I just picked up a L48 350 out of a 79 z28 yesterday and im starting a list of what im going to get for the rebuild but not sure how to cope with the (76cc) low compression heads, im going with factory spec internals besides a high lift cam, gear drive, and 1.6 roller rockers, I was thinking about a single plane high rise and My plans for the low comp. heads were to mill the heads, thinner head gasket and possible larger valves (2.02 and 1.6). From what ive read the heads are practically use less unless your force inducted. I have a set of early model vortec 54cc heads off my old 305 if it came down to swapping...give me some ideas on what I should revise/add to my list!!!
#2
Moderator
iTrader: (14)
Join Date: Mar 2000
Location: Littleton, CO USA
Posts: 43,169
Likes: 0
Received 35 Likes
on
34 Posts
Car: 82 Berlinetta/57 Bel Air
Engine: LS1/LQ4
Transmission: 4L60E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
Re: 79 350 with 76cc heads LOW COMP.!!!
Same post in another forum is getting responses.
So,
So,
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Tech / General Engine
4
09-17-2020 08:26 AM
theshackle
Tech / General Engine
4
03-05-2017 06:37 PM
NinjaNife
Tech / General Engine
27
08-23-2015 11:49 AM