Dons headers
11-08-2015, 03:20 PM
#1
Dons headers
I have a question we are installing the L98 back in the 89 Iroc and we need to know if there is a problem installing the Dons headers after the engine is in and the engine has AFR heads
Last edited by Mirror Image; 11-08-2015 at 04:58 PM.
11-12-2015, 12:51 PM
#2
Supreme Member
iTrader: (1)
Join Date: Sep 2005
Posts: 26,115
Received 1,688 Likes
on
1,283 Posts
Car: Yes
Engine: Usually
Transmission: Sometimes
Axle/Gears: Behind me somewhere
Re: Dons headers
It's MUCH easier to install headers - ANY headers - with the engine out. Lay em in the engine compartment as you lower the motor, leave em loose from each other and the rest of the exhaust, and bolt em up to the heads, before securing the motor to the mounts.
Can be done afterwards, but is MUCH easier this way.
Don't think AFR heads has anything to do with it one way or the other.
Can be done afterwards, but is MUCH easier this way.
Don't think AFR heads has anything to do with it one way or the other.
11-12-2015, 06:09 PM
#4
Senior Member
iTrader: (10)
Join Date: Jan 2009
Location: Edmonton, Alberta.
Posts: 718
Likes: 0
Received 1 Like
on
1 Post
Car: 1988 Pontiac Trans Am GTA.
Engine: 385 stroker sbc
Transmission: TKO600
Axle/Gears: Moser 9" 3.70 Wavetrac
Re: Dons headers
Ive had my motor out numerous times and have never had a problem laying them in afterwards. Just pull the plugs and they'll slide right in. I have a custom steering shaft so it helps with clearance on the driver side.
Wrap them in saran a wrap if you are concerned of scratching the ceramic coating.
You wont have an issue installing them after.
Wrap them in saran a wrap if you are concerned of scratching the ceramic coating.
You wont have an issue installing them after.
Thread
Thread Starter
Forum
Replies
Last Post