Centerforce T56 flywheel (2pcRMS, int bal, 153 tooth)
01-18-2006, 01:58 PM
#1
Senior Member
Thread Starter
iTrader: (2)
Join Date: Aug 1999
Location: Elkton MD, USA
Posts: 858
Likes: 0
Received 5 Likes
on
3 Posts
Car: 1985 Camaro Z28, VIN F
Engine: 427 sbc, HSR
Transmission: T-56, self rebuilt 700+ hp
Axle/Gears: Moser 12bolt, 3.42 trutrac
Centerforce T56 flywheel (2pcRMS, int bal, 153 tooth)
http://store.summitracing.com/defaul...1&autoview=sku
P/N 700107
Lightly used flywheel to use a LT1-T56 trans on a internally balanced
SBC motor with a 2pc rear main seal (RMS).
May be able to clean up, or may need a slight resurfacing. Has not
been resurfaced before.
I purchased this for my T56 swap and then decided to go with a
Street Twin, which comes with a flywheel, so I don't need this one
now.
$250 + 1/2 shipping (UPS ground from ZIP 19711)[
P/N 700107
Lightly used flywheel to use a LT1-T56 trans on a internally balanced
SBC motor with a 2pc rear main seal (RMS).
May be able to clean up, or may need a slight resurfacing. Has not
been resurfaced before.
I purchased this for my T56 swap and then decided to go with a
Street Twin, which comes with a flywheel, so I don't need this one
now.
$250 + 1/2 shipping (UPS ground from ZIP 19711)[
Thread
Thread Starter
Forum
Replies
Last Post
monte87cortez
Transmissions and Drivetrain
2
09-26-2015 08:10 PM
