DSaylor

Anybody here using the edelbrock torque arm? Looking through their catalog and they have it priced at less than $220. Just wondering if anyone else is using it.

JamesC

iTrader: (5)

See my sig. $220? I paid less, but off the top of my head, I can't come up with a number (I purchased mine through Summit).

JamesC

Synapsis

I have it. It required cutting to fit my Borg-Warner rear axle, though.

EDIT: And it was cheaper than $220.

JamesC

iTrader: (5)

Hey, Synapsis,

I'm glad to hear that you got the arm installed. Because mine was a regular 10 bolt, I didn't experience any problems.

By the way, when I spoke to Edelbrock about the lost poly mount, I mentioned the packaging.

JamesC

poncho9789

I was looking into one of these torque arms before deciding on a Spohn I think the edelbrock are priced arround $150

Synapsis

That reminds me, DSaylor, if you get the Edelbrock torque arm, expect the box to be absolutely mutilated.

Yeah, I just had to cut the "E" logo out of the arm to get it to fit over the differential casing, then used two thick steel washers on one of the bolts. It's held up to the worst my 350 could throw at it at the strip.