eatmydust

I have a 350 that is pushing 450-500 hp and an unknown amount of torque. The guy I bought it from said he had it in his s10 and went through 4 rear ends and 3 trannys. I cannot afford this so I need the suspension, rear and tranny built enough to support this engine. I have Spohn LCA's, relocation brackets and Panhard bar, is there anything else I need besides stb and subframe connectors to help out? Thanks.

ebmiller88

iTrader: (7)

Maybe a Moser 12 bolt?

And a Lenco to go with it....



Ed

83 MidniteZ

New torque arm...and maybe some brakes to stop that thing!

Jackal8069

SFC's are a must! Poly bushings all around. I'd go and find a 12 bolt rear-end, or have a 10 bolt beefed up. And then find a damn good tranny- a TH400, or a muncie 4-speed. They're a bit big, but they're just what the doctor ordered when it comes to this much power. The 700R4 is a good tranny, but its "tempermental" when it comes to taking a flogging. But if you really like OD, thats the way to go....or with a T56 six-speed

Also, depending on the age of the car, replacing the door hinges could be a valuable proposition. The doors are actual load-bearing structures and having them sag allows the chassis to become flexable. The SFC's help in this respect, but it's good karma for the twisting on the top of the car to have them sit right.

eatmydust

Wow ok. Thanks. So, do LCA's and Panhardbar help out any?

Jackal8069

Yep they sure do! Thats only part of a well built suspension. You don't have to do everything to your car, but you need to make sure that whatever you do is well rounded and every mod to the rear suspension is complemented by an equal upgrade to the front suspension.