Building strut tower brace
03-04-2001, 08:28 PM
#1
Member
Thread Starter
Join Date: Nov 1999
Location: Woodstock, Ontario
Posts: 229
Likes: 0
Received 0 Likes
on
0 Posts
Building strut tower brace
Im thinking of building a strut tower brace as we have tons of supplies and the equipment required
What would be the best design to use and what size of pipe should i use?
Another question is should i make up some type of bracket that i weld to both wheel wells and bolt the bar to that? Or just bolt the brackets on?
It looks pretty simple i just dont wanna use too small of pipe or make the wrong design
thanks in advance for your advice
What would be the best design to use and what size of pipe should i use?
Another question is should i make up some type of bracket that i weld to both wheel wells and bolt the bar to that? Or just bolt the brackets on?
It looks pretty simple i just dont wanna use too small of pipe or make the wrong design
thanks in advance for your advice
03-06-2001, 12:42 PM
#2
Junior Member
Join Date: May 2000
Location: Willits California USA
Posts: 64
Likes: 0
Received 0 Likes
on
0 Posts
Go back and look over the last 20 days of this board. There is a thread with tons of the info you seek.
------------------
Nor Cal Mike
Red 84 Z28 HO, stock L82 350, L69 carb, intake, and air cleaner.
5 Spd, 3:73 Posi, 1 5/8" SLP headers, 3"cat connected to
stock L69 exhaust, KYB's, homemade SFC's,STB and wonderbar
Some are faster but mine's fast enough.
------------------
Nor Cal Mike
Red 84 Z28 HO, stock L82 350, L69 carb, intake, and air cleaner.
5 Spd, 3:73 Posi, 1 5/8" SLP headers, 3"cat connected to
stock L69 exhaust, KYB's, homemade SFC's,STB and wonderbar
Some are faster but mine's fast enough.
Thread
Thread Starter
Forum
Replies
Last Post