Tech / General Engine Is your car making a strange sound or won't start? Thinking of adding power with a new combination? Need other technical information or engine specific advice? Don't see another board for your problem? Post it here!

Trouble Code 33 on 89 GTA w/350

Thread Tools
 
Search this Thread
 
Old 05-28-2006, 04:26 PM
  #1  
Junior Member

Thread Starter
 
jgrist63's Avatar
 
Join Date: May 2006
Posts: 10
Likes: 0
Received 0 Likes on 0 Posts
Trouble Code 33 on 89 GTA w/350

The Service Engine Soon light on my 89 Trans Am GTA has been coming on. The stored trouble code is 33 - the FAQ section indicates that is a High Voltage (low vacuum) at the MAP sensor. If the car is at idle or low RPM, it may run very roughly or even stall. The idle/stall problem doesn't seem to occur if the car is at a crusing speed. Before I could get a valid trouble code, I had the spark plugs, plug wires, and O2 sensor replaced. Is there a common cause for this code or is it one of those codes that could be caused by a thousand different things? Thanks!

John
Old 05-28-2006, 04:34 PM
  #2  
Member
 
FireBirdKnight's Avatar
 
Join Date: Apr 2006
Location: michigan
Posts: 344
Likes: 0
Received 0 Likes on 0 Posts
Car: 1985 TransAm
Engine: 5.0L TPI
Transmission: 700R4 auto
Axle/Gears: 3.27 BorgWarner
even the slightest crack in a vacuum hose for map will **** it off triping a code check ur hoses for heat rot or cracks specially hoses under the TPI pendlium
Old 05-28-2006, 04:43 PM
  #3  
Junior Member

Thread Starter
 
jgrist63's Avatar
 
Join Date: May 2006
Posts: 10
Likes: 0
Received 0 Likes on 0 Posts
Don't think it's that

At first glance, the vacuum hose looks fine. I guess there might be a pin hole or smething but there's nothing obvious

Last edited by jgrist63; 05-28-2006 at 04:55 PM.
Old 05-28-2006, 05:24 PM
  #4  
Senior Member

 
John 89 Formula's Avatar
 
Join Date: Jul 1999
Location: Everett, MA . USA
Posts: 853
Likes: 0
Received 0 Likes on 0 Posts
Car: 89 FORMULA FIREBIRD, 86 CHEVY CAMARO
Engine: L98, LB9 RESPECTIVLY
Transmission: 700 R4 (BOTH)
Your car is an 89, it does not have a map sensor. Code 33 is a mass air flow sensor code. First thing I'd be looking at is the maf power and burn relays. Thier located on the firewall between the d/s fender and brake booster (the 2 oval ones).
Old 05-28-2006, 06:21 PM
  #5  
Junior Member

Thread Starter
 
jgrist63's Avatar
 
Join Date: May 2006
Posts: 10
Likes: 0
Received 0 Likes on 0 Posts
What do I need to look for on those relays?
Old 05-28-2006, 08:21 PM
  #6  
Senior Member

 
John 89 Formula's Avatar
 
Join Date: Jul 1999
Location: Everett, MA . USA
Posts: 853
Likes: 0
Received 0 Likes on 0 Posts
Car: 89 FORMULA FIREBIRD, 86 CHEVY CAMARO
Engine: L98, LB9 RESPECTIVLY
Transmission: 700 R4 (BOTH)
The relays are about 12 dollars at most parts stores I'd replace them both, also inspect the condition of the wiring on the connectors, any bare spots should be wrapped with elec tape.
Old 05-29-2006, 08:59 PM
  #7  
Junior Member

Thread Starter
 
jgrist63's Avatar
 
Join Date: May 2006
Posts: 10
Likes: 0
Received 0 Likes on 0 Posts
I replaced the relays - cost me $15 and took 10 minutes. The first results are encouraging. I drove it all afternoon in 95 degree heat with A/C blasting and lugging it to the mall, Target, etc. without any sign of the Service Engine Soon light.....

Keeping my fingers crossed

John
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
MantyZ28
Interior Parts for Sale
8
11-08-2015 06:54 PM
machinist21
Firebirds for Sale
0
09-05-2015 03:03 PM
RyanJB
TPI
0
09-02-2015 01:27 PM



Quick Reply: Trouble Code 33 on 89 GTA w/350



All times are GMT -5. The time now is 02:28 AM.