cant figure this out...
#1
Member
Thread Starter
Join Date: Jan 2001
Location: North Salem Ny United States
Posts: 257
Likes: 0
Received 0 Likes
on
0 Posts
Car: 86 Z-28
Engine: 356 4-bolt
Transmission: Borg warner T-5
cant figure this out...
i just mounted a v6 t5 behind my v8. I used a stock pressure plate and an advanced adapters friction disc from summit. The problem is when i push the clutch pedal it wont disengage, i cant get it into any gear. i have bled the hydraulics and still no better. what else could it be? It wont grind, it just feels like its hitting a wall with the shifter and wont go into gear. if you raise the rear of the car and try to put it in gear, it wont fully go into gear but the wheels will start to spin. what can i do?
#2
Supreme Member
iTrader: (1)
Join Date: Sep 2005
Posts: 26,130
Received 1,691 Likes
on
1,285 Posts
Car: Yes
Engine: Usually
Transmission: Sometimes
Axle/Gears: Behind me somewhere
Sounds like the clutch gear fits into the pilot bushing too tight. Maybe dinged up the pilot during install.
You DID put the throwout bearing onto the fork correctly, right? The spring thing with the fingers, is INSIDE the throwout bearing groove, not "clipped" onto the back of the throwout?
You DID put the throwout bearing onto the fork correctly, right? The spring thing with the fingers, is INSIDE the throwout bearing groove, not "clipped" onto the back of the throwout?
#4
Supreme Member
Join Date: Mar 2002
Location: Lower Salford, PA
Posts: 1,654
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1987 Camaro Z-28
Engine: 6.3L Victor EFI
Transmission: Tremec TKO 600
Axle/Gears: Moser 9"/4.11 Trac-Lok
Originally Posted by Dialed_In
disc in backwards?
Thread
Thread Starter
Forum
Replies
Last Post
RedLeader289
Tech / General Engine
10
05-28-2019 01:47 PM