What to do first?
Thread Starter
Supreme Member
iTrader: (1)
Joined: Mar 2002
Posts: 2,467
Likes: 1
From: The nation's capital
Car: 91 RS
Engine: 350 TBI
Transmission: 700R4
What to do first?
I plan on installing Spohn's SFC, but I'm not really sure of the location of the install....
Does it sit above the exhaust or below?
I was planning on installing Flowtech Headers w/ a Hooker Cat-Back, along with a shift kit for the tranny from TransGo and a posi unit, but I don't want to end up putting on the SFC and then not be able to get to any of that stuff.
Basically, I'm trying to formulate a plan of attack, and I don't want to paint myself in a corner.
Does it sit above the exhaust or below?
I was planning on installing Flowtech Headers w/ a Hooker Cat-Back, along with a shift kit for the tranny from TransGo and a posi unit, but I don't want to end up putting on the SFC and then not be able to get to any of that stuff.
Basically, I'm trying to formulate a plan of attack, and I don't want to paint myself in a corner.
Supreme Member
iTrader: (1)
Joined: Jul 2001
Posts: 1,828
Likes: 0
From: San Jose, CA
Car: 2002 Z28
Engine: LS1
Transmission: 4L60E
Axle/Gears: 3.23
The ends bolt to the front of the rear lower control arms, meaning only one possible position. I had alittle trouble getting the passenger side SFC over my Edelbrock Y Pipe, but me and the muffler shop guy were able to get it in there by pulling down on the Y pipe and softly hammering it into place.