Polishing plenum and aluminum dist. cover??
Thread Starter
Joined: Aug 1999
Posts: 492
Likes: 0
From: Aurora, ON, Canada
Car: 1989 Iroc-Z
Engine: 5.7L TPI
Transmission: 4 Spd Auto
Polishing plenum and aluminum dist. cover??
I just picked up one of those aluminum distributor covers to replace the plastic one and I was wondering what the best way to polish it up would be. I saw one thing for sale on ebay and it had a mirror finish and looked quite good. Any ideas for trying to get that sort of a finish and get rid of the rough cast aluminum surface??
Member
Joined: Dec 2001
Posts: 155
Likes: 0
From: Stupid Humor!
www.eastwoodco.com Look into polishing. It is not hard, just time consuming!
Senior Member
Joined: Oct 1999
Posts: 735
Likes: 2
From: Portales, NM USA
Car: 86 T/A
Engine: 5.0 TPI
Transmission: 700R4
Polishing Your Plenum
~~~~~~~~~~~~~~~~~~~~
Red 86 T/A 5.0 TPI (LB9/WS6)
~HyperTech Cap/Coil/Rotor/AFPR
~Derale Adjustable Fan Switch ~ 170° Stat
~Flow Matched Injectors ~ K & N Air Filter
~Ported Plenum ~ Pirelli 245/50/16
~SLP TB Airfoil ~ All Else Stock
~~~~~~~~~~~~~~~~~~~~
Red 86 T/A 5.0 TPI (LB9/WS6)
~HyperTech Cap/Coil/Rotor/AFPR
~Derale Adjustable Fan Switch ~ 170° Stat
~Flow Matched Injectors ~ K & N Air Filter
~Ported Plenum ~ Pirelli 245/50/16
~SLP TB Airfoil ~ All Else Stock
Last edited by MikeInAZ; Aug 20, 2006 at 04:34 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Hotrodboba400
Firebirds for Sale
3
Dec 10, 2019 07:07 PM
Hotrodboba400
Firebirds for Sale
0
Sep 2, 2015 07:28 PM