how are you suposed to put the horn botton on the grant steering wheel
how are you suposed to put the horn botton on the grant steering wheel
i was wondering if anyone knew any techniques on putting the horn botton on my grant steeringwheel. it will go on but i cant turn it straight to line it up. 
thanks
thanks
Joined: Aug 1999
Posts: 19,282
Likes: 103
From: Lawrence, KS
Car: Met. Silver 85 IROC/Sold
Engine: 350 HO Deluxe (350ci/330hp)
Transmission: T-5 (Non-WC)
Axle/Gears: Limited Slip 3.23's
Humm. I'm not sure what kind of wheel/button you have, but mine simply pops in and out and swivels in whatever manner I wish.
JamesC
JamesC
Senior Member
Joined: Aug 2001
Posts: 838
Likes: 0
From: garfield, nj
Car: 86 Z28
Engine: 355 carbed
Transmission: t-5
Mine you kind of have to pull this metal bracket out of the inside. And put that in the wheel first then it pops in and stays there. You can turn it where ever you want.
Supreme Member
Joined: Jul 1999
Posts: 1,431
Likes: 1
From: Huntsville, AL
Car: '00 Chevrolet Corvette
Engine: LS1
Transmission: 4L60E
Axle/Gears: 2.73
Do you have a Challenger wheel? I've got one on my car and I couldn't ever figure out how to adjust it either. It reads Grant almost straight up and down rather than straight across.
Junior Member
Joined: May 2002
Posts: 44
Likes: 0
From: Winnipeg, Mb, Canada
Originally posted by twiztidz28
Mine you kind of have to pull this metal bracket out of the inside. And put that in the wheel first then it pops in and stays there. You can turn it where ever you want.
Mine you kind of have to pull this metal bracket out of the inside. And put that in the wheel first then it pops in and stays there. You can turn it where ever you want.
Thread
Thread Starter
Forum
Replies
Last Post
backtothe80s
Suspension and Chassis
33
Sep 5, 2015 12:39 AM