will lt1 covers fit on a miniram or even in theory with a little work?


TPIS really screwed up my miniram and i had to send it out....it was polished but i'm sure the new one won't be and i'd like to make it look somewhat nice without going through all that work again.

 

You'll probably have to fab up some brackets for the little mounting studs to screw into and possibly modify it at the rear a bit to clear the distributor or fuel rails.

 

i asked that question awhile back

 

I too would like to know. Someone makes a nice set of carbon fibre covers too that i would like to get a hold of. Oh wait, i powdercoated mine! Seriously though, this would be something i would like to know. That will happen i think if i go out and buy a used set to experiment with. I think it would look cleaner b/c it would cover up the wires that run along side of the fuel rails.