any out there? anyone on thirdgen.org have theirs setup for something similar?

also looking for an ls1 swap in a pontiac.

 

Still compiling parts here. So far stacked up in the garage:

Weld in 2" X 3" square tubing sub frame braces
750# linear rate front, 400# rear springs
KYB adjustables (struts front, shocks rear)
Custom torque arm (3/4" tubular steel tubing)
Custom pan hard bar (same 3/4" tubing)
Poly bushings

As well as any of the "free" panel stitch welding, control arm boxing, etc. that I can get my hands on while I'm under there.

Still needed:

T56 swap (someday)
Few minor parts for the LT1 converted intake (already have most of it)
194/160 valves and assoc. parts for recon. heads

Someday, it will be all done. Hopefully things go well and I get a raise this year to help me pay for the few things I still need. Stupid me, I went and saved over $120,000 over the life of the house loan by refinancing to a 15 year mortgage. Now the toys have to wait!