refinishing wheels
#1
Member
Thread Starter
Join Date: Mar 2000
Location: Winnipeg,Manitoba,Canada
Posts: 250
Likes: 0
Received 0 Likes
on
0 Posts
refinishing wheels
what is the best way to completley redo regular z28 rims. i was think sanblasint the entire rim, and than polishing the rased aluminum, what do you guys think
------------------
when the green flag drops the bull$hit stops
350,performer RPM intake ,650dp, 700r4, headers, 3inch exhast
------------------
when the green flag drops the bull$hit stops
350,performer RPM intake ,650dp, 700r4, headers, 3inch exhast
#2
I would not touch machine tools. I got my formula WS6 wheels looking like glass by hand.
First buy about 3 cans of Airplane paint remover from any auto zone or advanced auto.
Spray it on the wheels (tape up what you dont want polished). Remove the clear coat. Use No.7 rubbing compound and water to buff out aluminum. Follow up with MOTHERS polish. Came out like glass.
by the way, i used a dremel at the lowest RPM setting and it left burn marks. I had to wet sand them out.
[This message has been edited by theformula (edited September 27, 2000).]
First buy about 3 cans of Airplane paint remover from any auto zone or advanced auto.
Spray it on the wheels (tape up what you dont want polished). Remove the clear coat. Use No.7 rubbing compound and water to buff out aluminum. Follow up with MOTHERS polish. Came out like glass.
by the way, i used a dremel at the lowest RPM setting and it left burn marks. I had to wet sand them out.
[This message has been edited by theformula (edited September 27, 2000).]
Thread
Thread Starter
Forum
Replies
Last Post
drptop70ss
Engine/Drivetrain/Suspension Wanted
3
10-04-2015 09:44 PM