wheel spacers!!!
Thread Starter
Supreme Member
iTrader: (3)
Joined: May 2004
Posts: 2,233
Likes: 4
From: stockton, CA
Car: Camaro RS/SS
Engine: 5.7 LS1
Transmission: 4L60E Transgo shift kit, 3500 stall
Axle/Gears: 4th Gen Rear 3:42
wheel spacers!!!
so if i go with the wheel spacers from hawks i would be able to fit the zo6 rims on my car right??? the spacers from hawks are also for the 4gen rims right???
Supporter/Moderator
Joined: Sep 1999
Posts: 888
Likes: 6
From: West Hartford, CT
Car: '89 Z28tt
Engine: Dart Little M Twin Turbo
Transmission: T56
Depending on the thickness of their billet adapters and which Z06 rims (width and offset), it may or may not work.
You can also go with thinner adapters in the rear, since there is more room on the inside of the wheelwell, but the outside of the rim won't be even w/ the front and may look a little "off".
Take a look at http://www.skulte.com/adapterfaq.html to help figure out what thickness you need. I hope this helps!
Andris Skulte
You can also go with thinner adapters in the rear, since there is more room on the inside of the wheelwell, but the outside of the rim won't be even w/ the front and may look a little "off".
Take a look at http://www.skulte.com/adapterfaq.html to help figure out what thickness you need. I hope this helps!
Andris Skulte
Thread
Thread Starter
Forum
Replies
Last Post
punkmaster98
Interior Parts for Sale
0
Sep 8, 2015 09:45 PM