slightly different cowl design-what do you think
slightly different cowl design-what do you think
Hey guys,
I came across this hood (don't even remember where, but could have been on this board).
I actually kinda like the design because it is cowl, but it is more subtle (goes wider and doesn't rise straight up at the edge) than the standard ones. I was thinking of getting it for my car which I will paint all black.
What do you think? With s&h it will probably be more than $600, but it is the only one with this kind of design that I found (anyone see this somewhere else)
Also, if you guys have comments about the company itself, G&T Fiberglass, I started a thread in vendor review
Any comments would be welcome.
I came across this hood (don't even remember where, but could have been on this board).
I actually kinda like the design because it is cowl, but it is more subtle (goes wider and doesn't rise straight up at the edge) than the standard ones. I was thinking of getting it for my car which I will paint all black.
What do you think? With s&h it will probably be more than $600, but it is the only one with this kind of design that I found (anyone see this somewhere else)
Also, if you guys have comments about the company itself, G&T Fiberglass, I started a thread in vendor review
Any comments would be welcome.
TGO Supporter
Joined: Oct 2003
Posts: 2,069
Likes: 0
From: ready room
Car: NCC-1701-D (docked in AZ)
Engine: impulse drive
Transmission: fusion reactors
Axle/Gears: Rescued from the Borg by my crew
Re: slightly different cowl design-what do you think
Originally posted by VILeninDM
Hey guys,
I came across this hood (don't even remember where, but could have been on this board).
I actually kinda like the design because it is cowl, but it is more subtle (goes wider and doesn't rise straight up at the edge) than the standard ones. I was thinking of getting it for my car which I will paint all black.
What do you think? With s&h it will probably be more than $600, but it is the only one with this kind of design that I found (anyone see this somewhere else)
Also, if you guys have comments about the company itself, G&T Fiberglass, I started a thread in vendor review
Any comments would be welcome.
Hey guys,
I came across this hood (don't even remember where, but could have been on this board).
I actually kinda like the design because it is cowl, but it is more subtle (goes wider and doesn't rise straight up at the edge) than the standard ones. I was thinking of getting it for my car which I will paint all black.
What do you think? With s&h it will probably be more than $600, but it is the only one with this kind of design that I found (anyone see this somewhere else)
Also, if you guys have comments about the company itself, G&T Fiberglass, I started a thread in vendor review
Any comments would be welcome.
Thread
Thread Starter
Forum
Replies
Last Post





