ss hood/strut tower brace
Thread Starter
Senior Member
iTrader: (1)
Joined: Sep 2001
Posts: 643
Likes: 0
From: Mechanicsburg,Pa usa
Car: 92'Camaro RS
Engine: a loud one
Transmission: bolted to the engine
ss hood/strut tower brace
Anyone running a combination of the two. I have an edelbrock STB and the stock hood closes fine but the ss hood won't close . Anyone else run into this problem?
Joined: Jul 1999
Posts: 1,421
Likes: 24
From: Stavanger area, Norway
Car: 86 IROC Convt
Engine: 305TPI
Transmission: TH700R4
I have a BMR stb under the SS hood and it is a very tight fit. Infact, it barely touches the hood. So if your stb is any taller than the BMR, there is going to be a conflict.
Ken
Ken
Thread
Thread Starter
Forum
Replies
Last Post
