Graeme'sFirebird

When i was getting an estimate i was offered adhesion sanding or a 3 step full body sanding. The $ difference is 100 bucks. Would it be worth it? Basically he said they sand the whole car for adhesion, go over it again, and end with a fairly light grit sand paper to give a perfect adhesion surface. Ideas?

------------------
89 Firebird (AKA "Money")
2.8 V6 w/ t5 tranny (383 tpi t56 12/01)
Flowmaster 80 series, 3" Intermediate, SS Tips, Random Tech Cat, Msd Coil, MSD 6a, Accel 8.8 wires, Cold Air Intake w/ K&N, Lakewood LCA's, Brushed aluminum Hood pins ETC...
Next:
Spohn Torque Arm, Lakewood Panhard bar, BMR Fabrication Sub Frame connectors...
-------------------------
My Site:
www.geocities.com/firebird89white

" I'd rather run last in a full out race, than to NOT run at all ".

Ovrclck350

I think I'd go with the full body sanding. That way you NEVER have to worry about flaking, because if they just paint over the old stuff, when it decides to flake, so does the new stuff.

------------------
See pics @ Billy's Firebird
92 Bird 3.1L Auto
Best $750 I ever spent....
DRIVE IT LIKE YOU STOLE IT!
Kills:
93 Mustang LX (Before Mods)
98 or 99 Dodge Stratus (tough one, edged out at 40)
92 Camaro RS 305 TPI
Close Calls
94 Grand Am 3.1 V6
92 Cavalier 3.1 V6
01 Porsche 911 Turbo (Had em till first gear)
Mods-Jet Stage 2 Performance Chip, Accel Cap/Rotor, Accel 8.8 MM Wires, Accell Coil, AC Delco Rapidfire Plugs, Dynomax Catback, K&N
AIM name OVRCLCK350