who knows
Thread Starter
Member
Joined: Apr 2006
Posts: 290
Likes: 1
From: Columbus
Car: 88 Formula, 72 Nova, 68 Chevelle
Engine: L98, mild 350, L79 327
Transmission: 700R4, M20, M20
Axle/Gears: 9b 327,10b 373, 12b 331
who knows
i will be painting my firebird in the spring and was going to do it in the original bright red but have since decided that the car would look so mean in satin black. does anyone know of a satin black paint, i know primers are easy to find in black but unless i clear coat it wont it surface rust though the primer? I would like a finished smooth "top coat" like finish just in satin black, and yes i will be putting a silver formula decal kit on the car when it is black.
Joined: Aug 2006
Posts: 12,804
Likes: 103
From: Central NJ
Car: 86 Trans Am
Engine: 408 stroker sbc
Transmission: TKO600
Axle/Gears: Moser full floater m9, 3:70 trutrac
you can apparently get a satin/flatish clear coat that will make the desired finish
COTM Editor
iTrader: (11)
Joined: Mar 2006
Posts: 4,098
Likes: 13
From: WINDSOR, CO
Car: 91 Z28, 87 SC, 90 IROC, 92 RS
Engine: LS1, 305 TPI, L98, NADA
Transmission: T56, 700r4's, and NADA
Axle/Gears: 3.89, 3.42, 3.23, NADA
I believe that this same question has been asked multiple times on the body board. Check there! I am sure I read one post where someone listed out part numbers and explained the process.