4th Gen seats in a #rd Gen?!?!?
Thread Starter
Junior Member
Joined: Feb 2001
Posts: 95
Likes: 0
From: Plano Tx US
4th Gen seats in a #rd Gen?!?!?
I have a 91 Z28 with grey cloth interior. I am looking to find some used grey leather seats from a 4th gen to put in mine. I have heard that the brackets are the same so it will fit right in. Can any body give me any help?
------------------
91 camaro Z28:K&N's, flowmaster 3" cat-back exhaust, competition stero, strut tower brace, ZR1 chrome rims, eibach springs, slp headers, msd wires, bosch +4 plugs, throttle-body-bypass, kyb shocks-struts, airfoil
------------------
91 camaro Z28:K&N's, flowmaster 3" cat-back exhaust, competition stero, strut tower brace, ZR1 chrome rims, eibach springs, slp headers, msd wires, bosch +4 plugs, throttle-body-bypass, kyb shocks-struts, airfoil
TGO Supporter
iTrader: (2)
Joined: Jul 1999
Posts: 13,579
Likes: 9
From: Readsboro, VT
Car: 85 IROC-Z / 88 GTA
Engine: 403 LSx (Pending) / 355 Tuned Port
Transmission: T56 Magnum (Pending) / T5
Axle/Gears: 3.42 / ?
Been damned near a week since somebody asked that! I was wondering when the next one would be. 
------------------
The IROC Homepage
<A HREF="http://www.rit.edu/~jli4307/camaro" TARGET=_blank>
View the restoration of an 85 IROC</A>
"I didn't know a bored out Ford could go so slow" -Shenandoah
------------------
The IROC Homepage
<A HREF="http://www.rit.edu/~jli4307/camaro" TARGET=_blank>
View the restoration of an 85 IROC</A>
"I didn't know a bored out Ford could go so slow" -Shenandoah
Supreme Member
Joined: Nov 2000
Posts: 1,760
Likes: 0
From: Newark, DE
Car: 86' Z28
Engine: 355
Transmission: T-56
<font face="Verdana, Arial" size="2">
I think they should just put in big red letters on the top of the board "4th gen seats will fit inot a 3rd gen", but I guess it still wouldn't stop some people from asking.
-Max </font>
I think they should just put in big red letters on the top of the board "4th gen seats will fit inot a 3rd gen", but I guess it still wouldn't stop some people from asking.
-Max </font>
Eric
------------------
My 1986 Z28
GM350, T-5, 3.23's, lots of go fast goodies, 4th gen Firebird interior etc...
85 IROC w/ 1364 miles!
You'll always find what you've lost in the last place you look
R.I.P Dale Earnhardt
Junior Member
Joined: Jun 2001
Posts: 35
Likes: 0
From: memphis,tn,usa
The seats are a direct bolt in but you will have to splice the connectors for the power seats. the connector ends are different. should take longer than ten minutes. A cut here, some solder there, a little tape there. Presto, POWER SEATS!!!
Thread
Thread Starter
Forum
Replies
Last Post