Re-invent the IROC Z logo
Thread Starter
TGO Supporter
iTrader: (1)
Joined: May 2002
Posts: 2,480
Likes: 2
From: El Paso, Texas
Car: 1987 IROC Z
Engine: 350 TPI L98 block
Transmission: 700R4
Re-invent the IROC Z logo
So I was looking at a lincoln MKZ today and the "Z" caught my attention as I thought it would be cool to put IROC Z on my IROC using badging from a different vehicle . The question is " What vehicle has cool badging that could be used to spell out IROC Z ?
Joined: Jan 2007
Posts: 976
Likes: 4
From: Newfoundland, Canada
Car: 1991 Pontiac Trans Am GTA
Engine: V8 305
Transmission: Automatic Transmission
Re: Re-invent the IROC Z logo
maybe the "intimidator" font used on the Dale Earnhardt Monte Carlo, not this best picture sorry.
Thread Starter
TGO Supporter
iTrader: (1)
Joined: May 2002
Posts: 2,480
Likes: 2
From: El Paso, Texas
Car: 1987 IROC Z
Engine: 350 TPI L98 block
Transmission: 700R4
Re: Re-invent the IROC Z logo
Member
Joined: Oct 2007
Posts: 154
Likes: 0
From: San Antonio, Tx
Car: 1987 Trans Am WS6
Engine: 305 tpi
Transmission: Auto
Re: Re-invent the IROC Z logo
I gave a shot at redoing the camaro logo which was very hard because of the design.

also gave a shot at the firebird to which was done for my local fbody club.

-Buddy-

also gave a shot at the firebird to which was done for my local fbody club.

-Buddy-
Member
iTrader: (1)
Joined: May 2003
Posts: 457
Likes: 1
From: NC
Car: '91 Camaro Z28
Engine: 383 Vortec HSR
Transmission: Pro-Built 700-R4;Vig 4000 stall
Axle/Gears: Moser M9 9" / 3.89
Member
Joined: Jun 2005
Posts: 409
Likes: 0
From: Tri-Cities
Car: 1991 pontiac Firebird
Engine: 305 tbi, Lo3 (for now)
Transmission: auto
Axle/Gears: stock (for now)
Re: Re-invent the IROC Z logo
Make your own. I had made an LT1 badge, until I sold the engine.... I started with .125 aluminum. After that, cut it how you like. Polish it, clear it (I was going to use a clear powdercoat) and use the emblem adhesive from the local parts store.
After I figure Ill make one, after I decide what engine Im going to use.
After I figure Ill make one, after I decide what engine Im going to use.
Trending Topics
Thread Starter
TGO Supporter
iTrader: (1)
Joined: May 2002
Posts: 2,480
Likes: 2
From: El Paso, Texas
Car: 1987 IROC Z
Engine: 350 TPI L98 block
Transmission: 700R4
Re: Re-invent the IROC Z logo
Thread
Thread Starter
Forum
Replies
Last Post
1Aauto
Sponsored Vendors
10
Apr 9, 2018 03:00 PM
1Aauto
Sponsored Vendors
0
Aug 26, 2015 02:18 PM
mustangman65_79
Body
3
Aug 11, 2015 03:17 PM











