Need some measurements...
Thread Starter
Member
iTrader: (2)
Joined: Sep 2010
Posts: 397
Likes: 0
From: Birmingham, AL
Car: 1984 Camaro Z28 Clone
Engine: Bored .030, vortec sbc350
Transmission: Built T5 WC
Axle/Gears: 1999 Torsen 4:10 Locker
Need some measurements...
Guys I need some measurements for the mounting holes for the rocker panels.
I am working on my iroc clone and because the SC didn't have the rocker panels there are no mounting holes...
wondering if anybody can send me the measurements for where each hole needs to be for the front and rear taps for the rocker panel.
Would be greatly appreciated.
I am working on my iroc clone and because the SC didn't have the rocker panels there are no mounting holes...
wondering if anybody can send me the measurements for where each hole needs to be for the front and rear taps for the rocker panel.
Would be greatly appreciated.