Don't know where else to post this...
Thread Starter
Member
Joined: Jun 2010
Posts: 264
Likes: 0
From: Nc
Car: 91 camaro rs
Engine: 305 (350 vortec in dec.)
Transmission: Wc-T5
Axle/Gears: 3.08 (3.42 in dec.)
Don't know where else to post this...
Does anyone know what the plastic piece that goes around the hood latch is called? Has the plastic clips holding it to the front support and front bumper, covers the gap between the front bumper and support. I want to get a stainless piece made, but mine is shattered and I need a pic of the whole piece to go by, any help would be awesome, thanks
Member
iTrader: (10)
Joined: Jul 2008
Posts: 426
Likes: 2
From: Binghamton, NY
Car: 1986 IROC-Z
Engine: 360cu @ 10.5:1
Transmission: T56 - Pro 5.0
Axle/Gears: 4.10 - Zexel Torsen - Moser Axles
Re: Don't know where else to post this...
We made one, it's not hard to do, but it's much easier if you have one in front of you to go by instead.
Thread Starter
Member
Joined: Jun 2010
Posts: 264
Likes: 0
From: Nc
Car: 91 camaro rs
Engine: 305 (350 vortec in dec.)
Transmission: Wc-T5
Axle/Gears: 3.08 (3.42 in dec.)
Re: Don't know where else to post this...
I have mine, but it's not complete, the back is missing and the center is shattered, thank you
Member
iTrader: (1)
Joined: Sep 2011
Posts: 330
Likes: 1
From: Illinois
Car: 88 Iroc-Z Convertible
Engine: 305 TPI
Transmission: 700R4
Re: Don't know where else to post this...
Probably worth it to just get one at a scrapyard. Or call Hawks or THirdgenRanch. they can probably get you a used one as well.
Thread
Thread Starter
Forum
Replies
Last Post
eightsixseven
Tech / General Engine
2
Dec 16, 2024 01:50 PM