Two dual A-pillet pods?
Thread Starter
Supreme Member

Joined: Aug 1999
Posts: 2,441
Likes: 1
From: sweden
Car: GTA -89
Engine: Blown 415"
Transmission: 4L80E
Axle/Gears: Strange 12-bolt
Two dual A-pillet pods?
Since autometers tripple pod isnt avalible I was thinking of getting two dual pods and place them on the A-pillar is this possible? How would it look?
I need to have atleast three gauges on the pillar......
FP+A/F+Boost.........
I need to have atleast three gauges on the pillar......
FP+A/F+Boost.........
Thread Starter
Supreme Member

Joined: Aug 1999
Posts: 2,441
Likes: 1
From: sweden
Car: GTA -89
Engine: Blown 415"
Transmission: 4L80E
Axle/Gears: Strange 12-bolt
Nevermind got an answer from autometer today:
Thank you for your interest in Auto Meter Products. I was just informed
that our part #12203 has been reinstated back into our line up of pillar
gauge pods. The triple full pillar gauge setup for your Camaro was
temporarily put on hold due to our overwhelming demand in other
products. Since the part has been taken off of our hold list, you can
now purchase this at any one of our distributors. Thank you again for
your interest in Auto Meter Products!
Sincerely,
Thank you for your interest in Auto Meter Products. I was just informed
that our part #12203 has been reinstated back into our line up of pillar
gauge pods. The triple full pillar gauge setup for your Camaro was
temporarily put on hold due to our overwhelming demand in other
products. Since the part has been taken off of our hold list, you can
now purchase this at any one of our distributors. Thank you again for
your interest in Auto Meter Products!
Sincerely,
Thread
Thread Starter
Forum
Replies
Last Post




